Wiring Instructions Photocell - Each wire set contains two insulated and one bare wire. Identify each wire terminal using the numbered labels, 1 through 4, for "Line" and "Load" terminal identification. Intermatic. Oct 12, 2012 · Photocell wiring Discussion in ' Electrical Wiring, Theories and Regulations ' started by cjlovejoy , Oct 12, 2012 . Discuss Photocell wiring in the Electrical Wiring, Theories and Regulations area at ElectrciansForums.co.uk.. Jan 05, 2013 · I doubt it will be a ballast, do you have a link to the instructions of the photocell? Some fancy switches only have two wires and require a minimum loading to work, others have a neutral connection and work with low wattage items..
3. Reference the National Electrical Code, ANSI/NFPA 70, specifically for the installation of wiring and clearances from power and lighting conductors. 4. Installation work and electrical wiring must be done by qualified person(s) in accordance with all applicable codes. The OFF position forces the control contactor to stay out or OFF. The AUTO position allows for photocell control. The proper voltage rated photocell must be used or damage will occur. Refer to the Lighting Control Contactor wire diagram for the specific photocell voltage (control voltage).. Connect the black wire from the photo-cell (outside wire) to the other 2 blacks. 6) Connect the middle wire from the photo-cell to the yellow wire. Connect the.
Expose the photocell wiring. Most photocells have three wires, color-coded black, white and red, and are connected between the lamp receptacle and the house wiring coming from the lamp post.. • READ INSTALLATION INSTRUCTIONS BEFORE WIRING • FOR OUTDOOR USE ONLY. MOUNT AT LEAST 12” (30.48 cm) ABOVE GROUND Wire Wireless Remote Photocell / Timer Dimmer Transformer Transformer, Photocell / Timer and Dimmer must be installed more than 12” (30.48 cm) above the ground.. If the photocell still does not function, measure continuity on the photocell wire (red/blue for 2-wire photocell or red/blue/green for 3-wire photocell) and check if it is shorted. If a short is found, the photocell is bad and needs to be replaced. Mis-wiring may have damaged the photocell..
The Woods 59408 Hard Wire Photocell is ideal for putting outdoor post lamps, driveway lights or security lamps on an "on at dusk, off at dawn" schedule automatically. It can also be used to control indoor lights. The unit fits into any standard outlet box, post lamp or wall pack.. Nov 30, 2010 · wiring for lights connected to timer and photocell. Discussion in 'Electrics live connection of the timer and then take a wire from the load connection of the timer to the live connection on the photo cell. then from the load connection of the photocell this goes to the lights and returns back to the photocell neutral connection. the. Installation Instructions FortressAccents Premium Transformer (40W) Input Wire Remote Output Wire Photocell Control Panel NOTE: PHOTOCELL MUST BE CONNECTED TO TRANSFORMER BEFORE TRANSFORMER IS INSTALLED Transformer must.
Photocell and Timer Wiring. Photocell and timer switch wires each have a line (black), load (red), neutral (white), and ground (green). The black line wire connects to line voltage from the panel, the red load wire connects to the light(s), the white neutral wire connects to the neutral wires of the circuit.. Jun 01, 2013 · The current photocell sensor has 3 leads; the lights have always been on until they all burned out. Whoever wired the lights ran a wire from the lights to the photocell sensor, and the wire only has two wires, a white and a black, and functions as a single pole light switch would..